Tag Archives: bullet puller

Ultimate Reloader: When Reloading Goes Wrong


From Ultimate Reloader : by Gavin Gear

When Reloading Goes Wrong: Hornady Cam Lock Bullet Puller

I’m going to load a bunch of 9mm today! That was my plan, and I couldn’t wait to go shoot a bunch of the ammo with my Glock 17. Everything was going “great” until I noticed the powder level seemed to be getting higher as I was loading. “That just doesn’t look right” I thought. I took a charged case off the press, and soon determined I was 2.2 grains over my 9mm load- way too far over to risk shooting. I won’t repeat what I said right then: something like @$#&. In disgust, I put the ammo aside in a tub with a sheet of paper laid inside with a Sharpie scrawl that read “Over, not safe”. I didn’t even want to think about breaking down 500 rounds of ammunition with my impact puller. That would probably take (:30 per cartridge X 500 cartridges = 250 minutes = ~4 hours and 15 minutes!). Later I decided it would be a good time to get a press-mounted collet puller. Hopefully that would save some time! Fast-forward a year later and I’m finally getting around to fixing this 9mm ammo. Feels good to take care of this pile of unsafe ammo.

As you saw in the video, this tool is pretty simple, but it’s magic when you need to pull a large quantity of bullets. I wouldn’t attempt this kind of job without such a tool! Here’s a look inside the die opening where the collet sits:

pulled down ammo using hornady cam lock bullet puller
The stages and components of pulled-down ammo.

Also pictured above: a “bad” cartridge before the bullet was pulled, the case, powder, and bullet after pulling (note the slightest ring from the taper crimp previously applied). I feel great about reusing these bullets for anything but a bullseye match- I don’t think the crimp groove or any of the “scratches” will affect the re-reloaded ammunition’s performance for most types of pistol shooting.

Here’s the parts and pieces for a typical Hornady Cam Lock Bullet Puller setup:

The components of the Hornady Cam Lock bullet puller
The components of the Hornady Cam Lock bullet puller

Pictured here:

  1. Cam Lock die body
  2. Cam lever
  3. Stem
  4. #9 collet – .338″ – .358″ range (9mm jacketed bullets measure .355″)

In order to use this tool, you’ll need the appropriate collet for each diameter range of bullets you intend to pull. From the Hornady Accessories Catalog:

cam lock bullet puller chart

You can find the Hornady Cam Lock Bullet Puller HERE at Midsouth Shooters Supply (click here for collets).

This puller worked great for me for the ~500 9mm cartridges that I had to tear-down and re-reload. I’m going to order more collets as the need arises, because I really like the way this tool works. Almost makes the process fun! If you’re looking to pull bulk bullets, check out this tool!